I could easily have spent a fortune replacing the motherboard, the memory, the processor etc when it all came down to 2 dollar battery. What's more is these batteries are easy to get. What you need is a CR2032 available at most hardware stores like home depot and I've even seen them sold in Safeways. Of course every reputable computer lithium stock store should stock them. Just check to make sure that your PC uses a CR2032 before you go to the shops!
To avoid this you can check date of manufacture and buy one that is more recently out the gates of the factory. As a workaround you can buy any netbook while it's under warranty test the battery and if it's not up lithium facts to your expectations you can send it back as dead on arrival and demand for a replace.
Even the best solution has internal resistance, which it discharges through over time, thus that optimal 40% capacity drips away. Another thing Lithium-Ion cells absolutely loathe apart from heat and being overcharged is being fully discharged.
Agitate the lithium bettery stock water gently until the light tells you it's done. UV purifiers don't work in murky water, so if that's the only water you have, you'll have to pre-filter it until it's not cloudy. You also need to make sure you don't drop a UV device.
Li-ion cells have a good peak output current and low source resistance. When you overload the tool, the voltage stays up, and they just keep pumping current into the motor. Power tools have thermal overload trips in the motors, and that's a good thing with Li-ion batteries, if they didn't they'd just burn the motor out!
Step 4 - Connect in the newly bought battery to the board of the iPod (where you unconnected the old battery) and set it on the glue that remained on the hard drive. Make sure that the battery and the wires are set properly so you can actually close the iPod. Snap the cover back together, you'll hear it when it's finished!